⬢Versions of the Original Prusa Enclosure manual:
⬢08/2022 - Initial version 1.00
⬢09/2022 - Updated to version 1.01
⬢10/2022 - Updated to version 1.02
⬢11/2022 - Updated to version 1.03
⬢05/2024 - Updated to version 1.1
EN
Login- Čeština
- Español
- Italiano
- Deutsch
- Polski
- Français
- Home
- Enclosure
- Assembly manuals
- Original Prusa Enclosure assembly (external display mounting)
- Manual changelog Enclosure kit
Manual changelog Enclosure kit
Menu
- Original Prusa Enclosure assembly (external display mounting)
- 1. Introduction
- 2A. Preparing the printer (MK4/S & 3.9/S)
- 2B. Preparing the printer (MK3S+ Black PSU)
- 2C. Preparing the printer (MK3S+ Silver PSU)
- 3. Assembling the enclosure
- 4A. Installing the printer (MK4/S & 3.9/S)
- 4B. Installing the printer (MK3S+ Black PSU)
- 4C. Installing the printer (MK3S+ Silver PSU)
- Manual changelog Enclosure kit
- 1. Versions history
- 2. Changes to the manual (1)
- 3. Changes to the manual (2)
- 4. Changes to the manual (3)
- 5. Changes to the manual (4)
- 5. Fire Suppression System (add-on)
- 6. Hinged Lid (add-on)
- 6A. Hinged Lid with MMU3
- 6B. Hinged lid with MMU2S
- 7. Advanced filtration system (add-on)
- 8. Mechanical lock (add-on)
- 9. Quick release PSU cable - MK3S+ Black PSU (add-on)
- 10. Quick release PSU cable - MK4/3.9 Black PSU (add-on)
- 11. White LED strip (add-on)
Manual changelog Enclosure kit
Relevant for:
Last updated 6 months ago Difficulty
Very easy Steps
5 Available languages
⬢09/2022 - Silver PSU installation.
⬢Added the Silver PSU installation instructions. Subsequently, necessary changes across the entire manual.
⬢09/2022 - New add-ons
Manual version 1.01
⬢10/2022 - New add-ons
Manual version 1.02
⬢11/2022 - Add-ons
⬢Added instructions for installing an external XP Power PSU for the White LED strip and Advanced filtration system add-ons.
⬢The Hinged Lid add-on manual now includes mounting the MMU.
Manual version 1.03
⬢05/2024 - applies to MK4, MK3.9, MK3S+ installation
⬢As of the end of May 2024, parts for mounting the display outside the enclosure are no longer included. Therefore, the display now remains on the printer inside the enclosure.
⬢A completely new procedure has been created for this Original Prusa Enclosure (with display inside) assembly manual.
⬢Manual version 1.1
Was this guide helpful?
Comments
Still have questions?
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.