• Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語

Polyamide (Nylon)

This article is also available in following languages: 

Basic info

Polyamide (Nylon) is a versatile material with excellent thermal and mechanical resistance. It is suitable for printing functional technical parts with high temperature and mechanical resistance requirements. However, it’s very hard to print and therefore recommended for experienced users only.
Recommended nozzle temperature: 285 °C
Recommended bed temperature: 110 °C
Heatbed: Special PA Nylon sheet will provide the best adhesion.


Polyamide is an extremely resilient material, resistant to abrasion, suitable especially for technical parts. It has excellent layer adhesion. In large volumes, it has great mechanical resistance, while in thin layers it remains flexible. Its coefficient of friction is low, melting temperature is high. However, polyamide is hygroscopic, so it is necessary to keep it dry (airtight with desiccant). Improper storage can lead it to absorb water weighing up to 10% of filament weight. Polyamides emit a strong odor with potentially dangerous ultrafine particles (UFPs) so printing in a well-ventilated room or in an enclosure is a must.

To compare supported material properties, see our material table. 



✔ Great mechanical resistance

✖ Prone to warping

✔ Tough in large volumes, flexible in thin layers

✖ Highly hygroscopic material

✔ High-temperature resistance


Best use

The best use of polyamide is for printing technical parts requiring great heat, chemical, and mechanical resistance. Pure polyamide is also good for making a cold pull cleaning.

Tips for successful printing

Keep the filament dry

Dry the filament before printing, at least 4 hours with a temperature below 90 °C. Moist polyamide filament makes bubbles, which leads to uneven layers and an ugly surface.

Print it in high ambient temperature

Print settings are usually quite similar to PC - with nozzle temperature around 285 °C. Apart from moisture issues, the main disadvantage of pure polyamide is warping. High ambient temperature (enclosure) helps a lot. However, you can get polyamides filled with carbon fibers, like our Prusament PA11 Carbon Fiber. These filaments don't warp by far as much as the unaltered versions and can be printed without an enclosure.

Sample prints

GearsBendable objects
Was this article helpful?


Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us