JA
  • English
  • Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login
Menu
Relevant for:
Last updated 4 years ago
This article is also available in following languages: 
ENCSPLDEESITFR

What happened?

The printer is displaying the message: Data is from unknown UV LED sensor!

Error name: UV data error

Error code: #10533

After calibration using the UV calibrator, the data was decoded successfully, but it was not possible to check its consistency. This is caused by using an unknown/unsupported calibrator.

How to fix it?

If you used the calibrator supplied by Prusa Research, please contact customer support.

If a third-party calibrator has been used you will need to purchase an Original Prusa UV calibrator from our e-shop.

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us