• Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語

Printer has not been calibrated yet

Last updated 2 years ago
This article is also available in following languages: 

The error message Printer has not been calibrated yet occurs after the assembly of your printer or after the Factory reset of all data. It will remain on the main LCD screen until you successfully calibrate the printer.


  1. Make sure you successfully finish the calibration. If the calibration is interrupted, with an error message or by the user, no calibration data is saved.
  2. You can perform the whole calibration process through our Wizard. Simply go to the LCD Menu -> Calibration -> Wizard, or you can go step by step doing the Selftest, XYZ calibration, and First layer calibration, individually.
  3. Once the calibration is finished, this error message will disappear and you will be able to safely use your printer.
If you are struggling with the calibration, see XYZ Calibration (MK3/MK3S/MK3S+) or XYZ Calibration (MK2/S).
Was this article helpful?


Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us