English
1. Tools necessary for this chapter
Step 1 of 21 (Chapter 3 of 20)
Contents
Comments
⬢For the following steps, please prepare:
⬢Phillips screwdriver PH2
⬢2.5mm Allen key
⬢Needle-nose pliers (flush cutters) for cutting zip ties
⬢Piece of cloth or fabric (at least 15x15 cm) for covering the heatbed
Loading...
Contents
Original Prusa Enclosure assembly (1.1)
- 1. Introduction
- 2A. Preparing the printer (MK4/S & MK3.9/S)
- 2B. Preparing the printer (MK3.5 Black PSU)
- Tools necessary for this chapter
- Preparing the printer
- Disconnecting the PSU cables
- Cutting off the zip-ties
- Removing the cable clips
- Releasing the PSU cables
- Guiding the cables: parts preparation
- Guiding the cables
- Guiding the cables
- Placing the printer
- Releasing the PSU
- Mounting the printer frame support: part preparation
- Mounting the printer frame support
- Covering the PSU cables: parts preparation
- PSU cables
- Covering the PSU cables
- Removing the FS-cover
- Installing the new FS-cover: parts preparation
- Installing the new FS-cover
- Haribo time!
- The printer is prepared
- 2C. Preparing the printer (MK3S+ Black PSU)
- 2D. Preparing the printer (MK3S+ Silver PSU)
- 3. Assembling the enclosure
- 4A. Installing the printer (MK4/S & MK3.9/S)
- 4B. Installing the printer (MK3.5 Black PSU)
- 4C. Installing the printer (MK3S+ Black PSU)
- 5. Fire Suppression System (add-on)
- 4D. Installing the printer (MK3S+ Silver PSU)
- 6. Hinged Lid (add-on)
- 6A. Hinged Lid with MMU3
- 6B. Hinged lid with MMU2S
- 7. Advanced filtration system (add-on)
- 8. Mechanical lock (add-on)
- 9. Quick release PSU cable - MK3S+ Black PSU (add-on)
- 10. Quick release PSU cable - MK4/3.9 Black PSU (add-on)
- 11. White LED strip (add-on)
- Manual changelog Enclosure
Comments
Log in to post a comment
No comments