EN
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Fan RPM out of test range #10127 (SL1/SL1S)

Menu
Relevant for:
Last updated 9 months ago
This article is also available in following languages: 
PLDEESITFR

What happened?

The printer is displaying the message: RPM of fan not in range!

Error name: Fan RPM out of test range

Error code: #10127

Issued if the RPM of any of the printer's fans is not within their limits of use when measured, during the calibration wizard.

Starting from firmware 1.7.0, this error replaces Fan RPM not in range #10122 (SL1/SL1S)

How to fix it?

The SL1/SL1S has three fans:

  • The LED cooling fan (indicated in the picture by a purple arrow on the left).
  • The right blower fan (indicated in the picture by a green arrow in the middle).
  • The filter fan (indicated in the picture by a blue arrow on the right).

If the warning appears, please follow the maintenance steps for the fan that generated the issue: SL1/SL1S maintenance. When doing that, also check the cable connections of the fan to the mainboard.

SL1 electronics wiring

 

SL1S electronics wiring

If the right blower fan is the one that showed the warning, make sure that the blower gasket is still in place.

Run the Selftest once again. For SL1, navigate to LCD menu -> Settings -> Recalibration; for SL1S, navigate to LCD menu -> Settings -> Calibration -> Selftest. In case the fan also fails during the self-test, switch the connection of two of the fans, and see if the warning will be transferred to the new fan. If the error is transferred, the fan that had the warning originally may need to be replaced.

How to replace the part?

In case you find some parts are faulty, please order them using our e-shop, then follow the service guide(s):

How to replace a blower fan (SL1)

How to replace a blower fan (SL1S)

How to replace a UV LED assembly (SL1)

How to replace a UV LED fan (SL1S)

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us