EN
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
Login

Prusa Connect setup (SL1/S)

Menu
Relevant for:
SL1SL1S
Last updated 3 months ago
This article is also available in following languages: 
PLDEESITFR

Starting from firmware 1.8.0, the Original Prusa SL1/S can be added to Prusa Connect. There are three ways to do it.

Touchscreen GUI on the printer

Go to the printer menu to Settings -> Network -> Prusa Connect -> Add Printer to Prusa Connect. There, you will see a QR code and near it a URL with a code at the end of it.

Scan the QR code with your smartphone camera or the Prusa app and log in to Prusa Connect.

Prusa Connect

If you are adding the printer through a computer, on the side of the QR code there is a URL with the code on the end of it. You can type the URL in your browser, or open Prusa Connect, go to Printers - Add printer, find your printer add, and the code shown on the printer screen.

Open PrusaLink and go to the Settings menu and under Connection, find the Link button. It will lead you to the Prusa Connect page in a new tab.

Was this article helpful?

Comments

Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us