The printer displays the message: The resin sensor was not triggered. Check whether the tank and the platform are properly secured.
Error name: Resin sensor error
Error code: #10307
Check the following items
If no issues are found in the tank or platform, check the resin sensor cable by opening the bottom cover.
|
|
|
On the side with the electronics boards from the printer, check if the serrated washer is in contact with the surface of the tilt, the cable is not damaged, and the connector is firmly connected to the board.
If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.