EN
    Login

    TMC overheat error #04202 (MMU)

    Menu
    Relevant for:
    MMU2SMMU3
    Last updated a year ago
    This article is also available in following languages: 

    What happened?

    Each of the three stepper motors on the MMU unit is controlled by a TMC driver on the control board. This message is shown in case the TMC driver for the Pulley motor is overheated.

    How to fix it?

    Make sure that there is sufficient airflow near the MMU board.

    If you are using the printer in an enclosure with elevated temperatures, use ventilation to cool down the printer’s environment.

    After that, restart the MMU unit and try the print again.

    Was this article helpful?

    Comments

    Still have questions?

    Still have questions?

    If you have a question about something that isn't covered here, check out our additional resources.
    And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

    Contact us