• Čeština
  • Español
  • Italiano
  • Deutsch
  • Polski
  • Français
  • 日本語

Emergency stop #13510 (MK4) #21510 (MK3.9) #23510 (MK3.5)

Relevant for:
Last updated 5 months ago
This article is also available in following languages: 

What happened?

The Original Prusa MK4/MK3.9/MK3.5 is showing the message: "Emergency stop invoked by G-code (M112)".

Error name: Emergency stop

Error code: #13510 (MK4) #21510 (MK3.9) #23510 (MK3.5)

This error message can be triggered during serial printing (e.g. Octoprint) and blocks the printer control. 

How to fix it?

Temporarily disconnect from your printer any external device, reboot the printer, and try printing using a FAT32 formatted USB drive. See if a different error would occur while printing via USB drive, and check the article relative to the new error. 

Are you still having issues? Contact our support team and let them know that you have tried to fix the issue with these instructions. We will take it from there.
Was this article helpful?


Still have questions?

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.

Contact us