Nozzle Heater Overcurrent #13308 (MK4) #21308 (MK3.9)

Relevant for:

MK4 MK3.9

Last updated 2 months ago

This article is also available in following languages:

What happened?

The Original Prusa MK4/MK3.9 is showing the message: "Overcurrent detected on nozzle heater."

Error name: Nozzle Heater Overcurrent

Error code: #13308 (MK4) #21308 (MK3.9)

The error is shown when there is a damaged cable on the hotend heater or any of its connections.

How to fix it?

The most likely cause of this issue is damage to the hotend heater cable. Check the path between the hotend heater and the LoveBoard, and see if there are any parts that are broken or pinched.

In case there is no damage, check the cable connection to the LoveBoard board. Try reconnecting the cable to its connector.

In rare cases, this error message can be shown in case of damage to the LoveBoard, or to the xBuddy board. So if the cables and connectors are intact, check the boards for any visible damage.

Always touch the sides of the electronic board while manipulating it. Avoid touching the chips, capacitors, and other parts of the electronics.

Was this article helpful?

Easy to understand

Solved my problem

Other reason

Comments

Still have questions?

If you have a question about something that isn't covered here, check out our additional resources.
And if that doesn't do the trick, you can send an inquiry to [email protected] or through the button below.